Dan-dugan-sound-design E Manual de usuario descargar pdf (Pagina 19)

Dugan Model E User Guide Installation

3.5 Linking

Multiple Model E units are linked in a ring so they operate as one system. Two standard

optical audio cables (i.e., ADAT lightpipe or Toslink) are required to link two mixers.

Note that using the digital I/O prohibits linking because there is only one set of connectors.

NOTE: This is different from the way the Models D and D-1 are linked.

Set one Model E to be the master by setting its rear panel NORM-SLAVE switch to the

NORM (up) position. Set all other linked units to be slaves by setting their rear panel

NORM-SLAVE switches to the SLAVE (down) position.

Link units in a ring configuration as shown below. Note that all LINK IN and OUT con-

nectors are used to create the ring.

Figure 3-5 Linking Model Es

NOTE: Model Es may be linked with Models D-2 or D-3. Model Es will be in group a.

OPTICAL LINK

OUT

Master

OPTICAL LINK

Slave

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Sin comentarios

Dan-dugan-sound-design E Manual de usuario Pagina 19