Dan-dugan-sound-design E Manual de usuario descargar pdf (Pagina 10)

Dugan Model E User Guide Quickstart

Digital I/O

The Model E may be connected to a digital mixing board with ADAT connections that

transmit eight channels on each digital audio optical cable. Connect the console ADAT

output to the Model E LINK IN, and the Model E LINK OUT to the board’s ADAT

input. On the mixing board, insert the ADAT inputs and outputs on each mic channel,

post-fader.

Figure 2-2 Digital connection

Step 2 Power-up Commnads

The Model E can execute six commands during power-up. Each command is selected

by holding down a specific button during the entire power-up process. Power-up is

complete after the bypass LEDs light sequentially and extinguish. The three com-

mands shown below are the most common. See Power-up Commands on page 17 to

learn about the additional modes.

Reset Audio

Hold the channel 1

bypass button down to set all parameters to factory default settings,

clear label text, and set the I/O to analog. We recommend starting an installation in this

mode.

Digital I/O

Hold the channel 3

bypass button down to switch all I/O to the ADAT link connectors.

Linking is not possible and the analog connectors are inoperative.

Analog I/O

Hold the channel 3 mute button down to switch all I/O to the analog connectors. Digital

connectors are available for linking.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Sin comentarios

Dan-dugan-sound-design E Manual de usuario Pagina 10