Dan-dugan-sound-design E-1 Manual de usuario descargar pdf (Pagina 43)

Dugan Models E-1 and E-1A User Guide

Chapter 5: Standalone Hardware Operation

The Dugan Control Panel software provides the complete complement of controls

for the Model E-1A. However, if for any reason you cannot or do not wish to connect

the Dugan Control Panel, you can operate the hardware as a standalone device.

The limitations in standalone operation are:

• Eight channels

• No access to channel weight controls,manmode, preset function, override function

• No unit or channel naming

• No access to groups, input/output level meters, or Master MUTE

Settings

1. Put all the live mic channels in automatic mixing mode by deactivating bypass

and mute.

2. Activate the mute buttons for all unused channels.

Figure 5-1 Channel displays and controls

3. Using a normal speaking voice, adjust the console input trim controls to the highest

possible gain without clipping.

The input gain to the Model E-1A should be high enough keep the level LED lit

green during silences. If the input trim controls do not provide enough level, set

the +4/-10 switch to the -10 position.

If the preamp gain controls are set too low, the inputs drop below their minimum

operating level. This causes downward expansion to prevent feedback but the

smooth ambience is disrupted.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Sin comentarios

Dan-dugan-sound-design E-1 Manual de usuario Pagina 43